Optimizing the monomer structure of polyhedral oligomeric silsesquioxane for ion transport in hybrid organic–inorganic block copolymers

Poly(ethylene oxide)-b-polyhedral oligomeric silsesquioxane (PEO–POSS) mixed with lithium bis(trifluoromethanesulfonyl)imide salt is a nanostructured hybrid organic–inorganic block copolymer electrolyte that may enable lithium metal batteries. The synthesis and characteristics of three PEO–POSS block copolymer electrolytes which only differ by their POSS silica cage substituents (ethyl, isobutyl, and isooctyl) is reported. Changing the POSS monomer structure results in differences in both thermodynamics and ion transport. All three neat polymers exhibit lamellar morphologies. Adding salt results in the formation of a disordered window which closes and gives way to lamellae at higher salt concentrations. The width of disordered window decreases with increasing length of the POSS alkyl chain substituent from ethyl to isobutyl and is absent in the isooctyl sample. Rheological measurements demonstrate good mechanical rigidity when compared with similar all-organic block copolymers. While salt diffusion coefficient and current ratio are unaffected by substituent length, ionic conductivity increases as the length of the alkyl chain substituent decreases: the ethyl substituent is optimal for ion transport. This is surprising because conventional wisdom suggests that ion transport occurs primarily in the PEO-rich domains, that is, ion transport should be unaffected by substituent length after accounting for the minor change in conducting phase volume fraction. © 2020 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2020 © 2020 Wiley Periodicals, Inc. J. Polym. Sci. 2020 , 58, 363–371     

The unusual tribological behavior of diamond-like carbon films under high vacuum

We fabricate F-doped and F-S-codoped diamond-like carbon (DLC) films using plasma-enhanced chemical vapor deposition system. The hardness, Raman spectra, and high-vacuum tribological behaviors indicate that the films are DLC films. The hardness is close related to the tribological properties of DLC films under high vacuum. The high hardness of DLC films would be helpful for obtaining the long lifetime under high vacuum. The lifetimes of F-S-codoped DLC films are about 120 and 140 seconds, which is attributed to the fast graphitization under high vacuum. The lifetime of F-doped DLC films is prolonged to the value of around 300 and 440 seconds, X-ray photoelectron spectroscopy analysis exhibits the existence of the “adsorption” F, and transmission electron microscopy analysis shows that the “adsorption” F could react with Fe to form layered FeF₂ nanocrystal at the initial sliding, which could be helpful for prolonging the lifetime of F-doped DLC films under high vacuum. This investigation opens a new window to overcome the disadvantage of F, S-doped DLC films under high vacuum.     

Curing behavior and properties of high biosourced epoxy resin blends based on a triepoxy monomer and a tricarboxylic acid hardener from 10-undecenoic acid

Renewable propane-1,2,3-triyl tris(9-(oxiran-2-yl) nonanoate) (EGU, 100 wt% biogenic) and a tricarboxylic acid triglyceride (CGTU) hardener (85.7 wt% biogenic) were synthesized from 10-undecenoic acid (10-UDA) and used to produce epoxy resins with 52–92 wt% biobased carbon. CGTU was prepared by thermally activated thiol-ene coupling of thioglycolic acid onto propane-1,2,3-triyl tris(undec-10-enoate), (GUD) in the absence of solvent. The characterized CGTU was used as a green hardener of blends based on EGU and a conventional bisphenol A-based epoxy pre-polymer (DGEBA) at various mass percentages (0–100 wt%) with an stoichiometric epoxy/acid equivalent ratio. Calorimetric studies revealed higher peak temperature, lower reaction heats, and longer gelation times in resins with high EGU proportion, evidencing the lower reactivity of aliphatic EGU compared with aromatic DGEBA. Cured resins were yellowish transparent rubber-like materials with glass transition temperatures (Tg) varying from −14 °C to −42 °C and tensile strength in the range of 1750 kPa–790 kPa, for 0 and 100 wt % EGU, respectively. The soluble fraction of all resins was less than 4.3%, reflecting a high level of crosslinking. Thermosets with high biobased content showed both UV-light protection and visible light transparency.     

含酰胺结构超低膨胀聚酰亚胺薄膜的热膨胀行为

采用联苯二酐与3种含酰胺结构二胺制备了具有不同取代基团的聚酰胺-酰亚胺薄膜, 考察了酰胺结构对薄膜力学、 耐热及尺寸稳定性的影响, 研究了聚集态结构与薄膜热膨胀行为的关系和规律. 该系列薄膜具有超高强度和优异的耐热性能, 拉伸强度高达280.5 MPa, 玻璃化转变温度在389~409 ℃, 并在30~300 ℃温度范围内表现出超低负膨胀, 热膨胀系数(CTE, ppm/℃, 即10 ⁶ cm·cm ^-1·℃ ^-1)在-3.05~-1.74 ppm/℃之间. 聚集态分析结果表明, 酰胺结构使分子链间形成了强氢键相互作用, 分子链在薄膜面内方向高度有序取向, 并在膜厚方向堆积更为紧密, 使薄膜表现出热收缩现象. 通过不同体积大小的取代基团进一步调控分子链间相互作用及排列堆积, 可实现薄膜在高温下近乎零尺寸形变, 为设计制备超低膨胀聚合物基板材料提供了新思路.     

改进的PNC方法及其在非线性偏微分方程多解问题中的应用

2017年，李昭祥等提出了一种偏牛顿-校正法（Partial Newton-Correction Method，简记为PNC方法），并利用它成功地计算出了三类非线性偏微分方程的多重不稳定解.本文在PNC方法的基础上，提出并发展了一种改进的PNC方法.首先，利用Nehari流形$\mathcal{N}$与零平凡解的可分离性，建立并证明了$\mathcal{N}$的某特殊子流形$\mathcal{M}$上的全局分离定理及其推广（即局部分离定理）.全局分离定理只跟非线性偏微分算子或相应的非线性泛函本身有关，而与具体的计算方法无关.对一些典型的非线性偏微分方程多解问题（比如，Henon方程问题），该全局分离定理的分离条件，经验证是成立的.另一个方面，通过修改或补充原辅助变换的定义，去掉了原辅助变换的奇异性；接着建立并证明了某些非线性偏微分方程问题的新未知解与该非线性偏微分算子零核空间的密切关系；在证明中，去掉了在原奇异变换下所需的标准收敛（standard convergence）假设.最后，计算实例与数值结果验证了改进的PNC方法的可行性和有效性；同时表明子流形$\mathcal{M}$与已知解的可分离性是PNC方法和本文新方法能成功找到多解的关键.     

乏燃料贮存格架跌落事故冲击分析和试验验证

乏燃料贮存格架是核电厂贮存乏燃料的重要设备，在满载条件下和地震/跌落事故中，都应保持稳定和安全状态．本文基于LS-DYNA对乏燃料贮存格架进行了跌落事故冲击分析，考虑了最重重物从可能最高处意外跌落的情况．分析时考虑了碰撞、几何大变形、材料非线性等非线性因素．分析发现，浅跌落情况下贮存格架变形较大，但为局部变形，冲击载荷不影响贮存格架的安全功能．深跌落情况下，组件跌落在支座上方时支座承受的载荷最大，并在许用载荷范围内．为确保核电厂安全性和可靠性，基于分析得到的现象，设计和开展了乏燃料贮存格架浅跌落和深跌落试验．试验采用了等比例贮存腔和真实燃料组件的管座．同时对试验件进行了跌落分析，并与试验结果进行了对比，验证了分析技术的保守性和准确性．掌握的分析技术可应用于所有压水堆核电站乏燃料贮存格架的跌落事故分析．     

基于多尺度方法的平动圆柱贮箱航天器刚——液耦合动力学研究

以充液航天器为工程背景,借助多尺度方法研究刚--液耦合动力学系统非线性动力学特性.利用多维模态方法,将描述横向外激励下圆柱贮箱中液体非线性晃动的自由边界问题转换为液体模态系数相互耦合的有限维非线性常微分方程组.推导液体晃动产生的作用于贮箱壁的晃动力和晃动力矩的解析表达式,进而建立航天器刚体部分平动和液体晃动耦合的非线性动力学方程组.应用多尺度方法对刚--液耦合系统的动力学特性进行解析分析,通过固有频率的特征方程求解耦合系统固有频率,推导外激励频率接近耦合系统第一阶固有频率时液体晃动稳态解的幅值频率响应方程.结合数值方法,研究了液体晃动稳态解的幅值频率响应曲线和激励--幅值响应曲线.结果表明, 随充液比变化,液体晃动稳态解的幅值频率响应曲线会发生软、硬弹簧特性转换现象和"跳跃"现象;幅值频率响应曲线的软、硬弹簧特性转换点受重力加速度和弹簧刚度系数影响;以上所得研究结果表明,考虑非线性效应时的刚--液耦合系统动力学特性与传统的线性系统模型所显示的动力学特性具有本质区别.本文的研究工作对进一步分析充液航天器刚--液耦合非线性动力学特性具有重要参考价值.      

PDα‐type distributed learning control for nonlinear fractional‐order multiagent systems

This paper considers the consensus tacking problem for nonlinear fractional‐order multiagent systems by presenting a PD^α‐type iterative learning control update law with initial learning mechanisms. The asymptotical convergence of the proposed distributed learning algorithm is strictly proved by using the properties of fractional calculus. A sufficient condition is derived to guarantee the whole multiagent system achieving an asymptotic output consensus. An illustrative example is given to verify the theoretical results.     

Existence and asymptotic properties of solutions for a nonlinear Schrödinger elliptic equation from geophysical fluid flows

In this paper, we study the existence and asymptotic behavior of radial solutions for a class of nonlinear Schrödinger elliptic equations on infinite domains describing the gyre of geophysical fluid flows. The existence theorem and asymptotic properties of radial positive solutions are established by using a new renormalization technique.     

我国A股房地产板块羊群效应研究

借助CSAD模型、马尔科夫转换模型和GARCH模型的研究结果表明我国A股房地产板块存在明显的羊群效应且存在如下特点:非对称性,扩张期较衰退期更为显著;规模差异性,大盘股较中小盘股更为显著;房地产调控政策影响的非对称性,紧缩政策较之宽松政策会诱发更加明显的羊群效应;产业链传染性,上下游行业中的羊群效应产生影响.非系统性风险和系统性风险都对A股房地产板块羊群效应产生了促进影响,且系统性风险的影响较大.